Upper Rear Feed Roll Stop (502 Series)

Kooima Ag #K502STOP

When your grinding ear corn, it can be a challenge to keep the feed rolls open wide enough to feed properly. On a Claas® 502 series machine, the upper feed rolls are controlled by hydraulic cylinders to monitor the crop flow. When doing ear corn the cylinders are too tight even on the lowest setting. The cylinder pulls the ear corn down and does not allow it to reach the cutter drum. Our remedy for this was to give the upper rear feed roll a new bottom stop. This goes right on the cylinder making it stay open to allow room for the ear corn. This is a must when grinding ear corn.

Watch the video below for installation instructions.

Compatible models:
  • Claas® 502
  • Claas® Adapters
Claas® is a registered trademark of Claas KGaA, MBH, which does not manufacture, distribute or endorse these parts.